About SIEMENS POWER SUPPLY 6EP1334-3BA10

Data Sheet: SITOP PSU200M/1-2AC/24VDC/10A

Article No.: 6EP1334-3BA10

SITOP PSU200M 10 A stabilized power supply

• Input: 120/230500 V AC

• Output: 24 V DC / 10 A

Input

• Type of power supply network: 1-phase and 2-phase AC

• Supply voltage at AC: Set by selector switch on the device

• Supply voltage 1 at AC: 120 ... 230 V

• Supply voltage 2 at AC: 230 ... 500 V

• Input voltage 1 at AC: 85 ... 264 V

• Input voltage 2 at AC: 176 ... 550 V

• Wide range input: Yes

• Overvoltage overload capability: 1300 Vpeak, 1.3 ms

• Buffering time for rated output current in case of power failure, min.: 25 ms

• Operating condition of mains buffering:

  • Vin = 120/230 V, typ. 150 ms

  • Vin = 400 V

• Line frequency: 50/60 Hz

• Line frequency range: 47 ... 63 Hz

Input Current

• At rated input voltage 120 V: 4.4 A

• At rated input voltage 230 V: 2.4 A

• At rated input voltage 500 V: 1.1 A

• Current limitation of inrush current at 25 C, max.: 35 A

• It value, max.: 4 As

Fuse Protection

• Type T 6.3 A (not accessible)

• Recommended miniature circuit breaker:

  • 1-phase operation: from 6 A (10 A) characteristic C (B)

  • 2-phase operation: 2-pole or circuit breaker 3RV2011-1EA10 (setting 3.8 A) or 3RV2711-1ED10 (UL 489) at 230 V; 3RV2011-1DA10 (setting 3 A) or 3RV2711-1DD10 (UL 489) at 400/500 V

Output

• Voltage curve: Controlled, isolated DC voltage

• Output voltage at DC rated value: 24 V

• Output voltage adjustable: Yes; via potentiometer

• Adjustable output voltage: 24 ... 28.8 V

• Relative overall tolerance of voltage: 3 %

• Relative control precision of output voltage:

  • On slow fluctuation of input voltage: 0.1 %

  • On slow fluctuation of ohm loading: 0.1 %

• Residual ripple, max.: 50 mV

• Voltage peak, max.: 200 mV

• Display for normal operation: Green LED for 24 V OK

• Type of signal at output relay contact: Normally open, contact rating 30 V DC / 0.1 A

• Behavior of output voltage when switching on: Overshoot of Vout approx. 3 %

• Response delay, max.: 1 s

• Voltage increase time, typical: 50 ms

Output Current

• Rated value: 10 A

• Rated range: 0 ... 10 A; +60 ... +70 C: Derating 2 %/K (120 V, 230 V) or 3.5 %/K (400 V)

• Supplied active power, typical: 240 W

• Short-term overload current: 30 A

• Duration of overloading capability: 25 ms

• Constant overload current: 12 A

• Bridging of equipment: Yes; switchable characteristic

• Number of parallel-switched equipment for increasing power: 2

Efficiency

• Efficiency: 91 %

• Power loss, typical at rated output voltage & current: 24 W

• Power loss, max during no-load operation: 6 W

Closed-Loop Control

• Relative control precision of output voltage with rapid input fluctuation 15 %, typical: 0.1 %

• Relative control precision of output voltage for load step 50/100/50 %, typical: 3 %

• Setting time:

  • Load step 50 100 %: 2 ms (typical)

  • Load step 100 50 %: 2 ms (typical)

  • Maximum: 5 ms

Protection and Monitoring

• Overvoltage protection: < 35 V

• Output short-circuit proof: Yes

• Short-circuit protection: Constant current approx. 12 A or latching shutdown

• Enduring short-circuit current RMS, typical: 12 A

• Display for overload/short-circuit: LED yellow "overload", LED red "latching shutdown"

Safety

• Galvanic isolation between input and output: Yes

• Safety extra-low output voltage Uout: acc. to EN 60950-1 and EN 50178

• Operating resource protection class: Class I

• Leakage current, max.: 3.5 mA; typical: 0.32 mA

• Protection class: IP20

EMC

• Emitted interference: EN 55022 Class B

• Mains harmonics limitation: EN 61000-3-2

• Interference immunity: EN 61000-6-2

Standards, Approvals, Certificates

• CE marking: Yes

• UL approval: Yes; cULus-Listed (UL 508, CSA C22.2 No. 107.1), File E197259; cCSAus (CSA C22.2 No. 60950-1, UL 60950-1)

• CSA approval: Yes; cULus-Listed, File E197259

• UKCA marking: Yes

• EAC approval: Yes

• Regulatory Compliance Mark (RCM): Yes

• NEC Class 2: No

• SEMI F47: Yes

• CB-certificate: Yes

• MTBF at 40 C: 1 055 408 h

Hazardous Environments

• IECEx: No

• ATEX: No

• ULhazloc: No

• cCSAus Class 1 Division 2: No

• FM registration: No

Marine Classification

• Shipbuilding approval: Yes

• American Bureau of Shipping Europe Ltd. (ABS): Yes

• French marine classification society (BV): No

• Det Norske Veritas (DNV): Yes

• Lloyds Register of Shipping (LRS): No

Environmental Product Declaration

• Environmental Product Declaration: Yes

• Global warming potential (CO2 eq):

  • Total: 763.9 kg

  • During manufacturing: 12.6 kg

  • During operation: 751 kg

  • After end of life: 0.18 kg

Ambient Conditions

• Operation: -25 ... +70 C; startup tested from -40 C nominal voltage

• Transport: -40 ... +85 C

• Storage: -40 ... +85 C

• Environmental category IEC 60721: Climate class 3K3, 5 ... 95 % no condensation

Connection Method

• Type: Screw terminal

• Input L, N, PE: 1 screw terminal each, 0.2 ... 2.5 mm

• Output +, -: 2 screw terminals each, 0.2 ... 2.5 mm

• Auxiliary contacts 13, 14 (alarm): 1 screw terminal each, 0.14 ... 1.5 mm

Mechanical Data

• Width Height Depth of enclosure: 70 125 121 mm

• Installation width mounting height: 70 225 mm

• Required spacing: Top 50 mm, Bottom 50 mm, Left 0 mm, Right 0 mm

• Fastening method: Snaps onto DIN rail EN 60715 35x7.5/15

• DIN-rail mounting: Yes

• S7 rail mounting: No

• Wall mounting: No

• Housing can be lined up: Yes

• Net weight: 0.8 kg 

Technical Details